11 updating your tool, Troubleshooting, Pid definitions – Actron CP9575 User Manual
Page 11
11
Updating Your Tool
1. Download Scanning Suite from http://www.Actron.com/down-
loads/.
2. Install Scanning Suite.
3. Connect USB Cable to Tool and PC.
If tool displays
PROGRAM MODE,
proceed to step 4.
If tool displays
DIAGNOSTIC MENU,
select SYSTEM SETUP.
From the system setup
menu, select PROGRAM
MODE and then proceed
to step 4.
4. Start Scanning Suite. Click on Tool Update Icon and follow in-
structions.
Troubleshooting
If a “LINK ERROR” message appears, cycle the ignition key
to the OFF position for 10 seconds, then back ON, then press
the
ENTER key. Make sure the ignition key is in the ON
n o t the ACCESSORY position.
If the MIL Status is ON and the MIL is not illuminated with the
engine running, then a problem exists in the MIL circuit.
PID Definitions
NOTE: Although over 300 PIDS are available, the Tool only
displays the PIDs the vehicle supports.
PROGRAM MODE
See User Manual
DIAGNOSTIC MENU
====================
System Setup
Drive Cycle Monitor
Vehicle Information
State OBD Check
View Data
View Freeze Data