Actron CP8217 - Manual

1
The manufacturer produces a full line of gauges
with many different styles.
1-1/2" Gauges
2” Gauges
2-5/8" Gauges
(See page 2 for hole sizes.)
MICROPROCESSOR-CONTROLLED ENGINES
3. It is recommended that the battery ground
cable be disconnected before any electrical
work is performed, especially when installing
Ammeters or Voltmeters.
4. Route all wiring and gauge tubing away from
linkages, high heat or moving parts.
5. Never smoke while working on your vehicle
and always keep a fire extinguisher nearby.
It should be rated for gas/chemical/electrical
fires.
6. Never lay tools on top of the battery or wear
jewelry during .electrical work to avoid severe
electrical shorts.
1. Read the entire instructions for your gauge
before proceeding.
2. Be sure the gauge is suitable for your vehicle:
• Does the gauge’s range cover the vehicle’s
operating range?
• Will the tubing of the mechanical gauges
reach from the engine connection point to the
gauge (temperature gauges cannot be length-
ened)?
• Is the vehicle’s electrical system 12 volt and
negatively grounded?
INSTALLATION & SAFETY PRECAUTIONS
INSTALLATION INSTRUCTIONS
GENERAL MOUNTING INSTRUCTIONS
GAUGE
DASHBOARD
BRACKET
NUTS &
WASHERS
Top View
Diagram 1
GAUGE MOUNTING
Gauges allow you to monitor the condition of
your vehicle and tell how well it is performing. If
there are any problems, you can detect them
immediately before they become severe. Warn-
ing lights only tell you when the problem already
requires immediate attention. You will find that
the addition of these gauges will add to your
peace of mind and driving comfort.
Many newer vehicles employ microprocessors
that control most of the engine and electrical func-
tions. Microprocessors are very sensitive electri-
cal components. Before installing any aftermar-
ket equipment consult the vehicle’s manufacturer
or shop manual to make certain that no damage
will result.
Some of these newer vehicles use electric cool-
ing fans or microprocessor engine controls that
depend on readings from the original equipment
sending units for correct operation. If your vehicle
is one of these you CANNOT replace the
sender(s) with any other. You can add an addi-
tional oil pressure sender with a “Tee Adapter Kit,”
but the only possible way to install a non OEM
water temperature sender is to install the new
sender in a different location, retaining the OEM
unit in its original location. Check with the vehicle’s
manufacturer or dealer to see if this is possible.
All gauges can be mounted into a surface of
your choice or into a panel. Single, dual & triple
gauge mounting panels are produced for all size
gauges. Some panels are in black or chrome
finishes. A fully chromed mounting cup is avail-
able for the 2-5/8" gauges.
1. Choose a location to mount the gauge where
it will be viewable from a normal driving posi-
tion (fuel pressure gauges should never be
mounted within the interior of the vehicle).
2. If you are using a mounting panel, mount it at
the chosen location with the screws provided.
If you are creating a hole, use the following sizes:
Gauge Style Hole Size
1-1/2" 1-5/8" (41 mm)
2" 2-1/16" (53 mm)
2-5/8" 2-5/8" (67 mm)
PARA NOMBRE, DOMICILIO Y TELEFONO DE IMPORTADOR: VER EMPAQUE.
INSTRUCCIONES GENERALES DE MONTAJE TENSIÓN 12 V
INSTRUCTIONS GÉNÉRALES DE MONTAGE
8
FULL ONE (1) YEAR WARRANTY
ACTRON MANUFACTURING CO.
15825 Industrial Parkway
Cleveland, Ohio 44135
1-800-228-7667
© 2004 Actron Manufacturing Co.
All Rights Reserved
0002-002-2376
Actron Manufacturing Company, 15825 Industrial Parkway, Cleveland, Ohio 44135, warrants to the user that
this unit will be free from defects in materials and workmanship for a period of one (1) year from the date of
original purchase.
Any unit that fails within this period will be repaired or replaced at Actron’s option and without charge when
returned to the Factory. Actron requests that a copy of the original, dated sales receipt be returned with the unit
to determine if the warranty period is still in effect.
This warranty does not apply to damages caused by accident, alterations, or improper or unreasonable use.
Expendable items, such as batteries, fuses, lamp bulbs, flash tubes are also excluded from this warranty.
ACTRON MANUFACTURING COMPANY DISCLAIMS ANY LIABILITY FOR INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES FOR BREACH OF ANY WRITTEN WARRANTY ON THE UNIT. Some states do not allow the
disclaimer of liability for incidental or consequential damages, so the above disclaimer may or may not apply to
you. This warranty gives specific legal rights, and you may also have rights which vary from state to state.
GARANTIA COMPLETA POR UN (1) AÑO
Actron Manufacturing Company, 15825 Industrial Parkway, Cleveland, Ohio 44135, garantiza al usuario que
esta unidad estará libre de defectos de materiales y mano de obra por un período de un (1) año a partir de la
fecha original de compra.
Toda unidad que falle dentro de este período será reparada o reemplazada a la opción de Actron y sin cargo
cuando sea devuelta a la fábrica. Actron requiere que se devuelva una copia del recibo original fechado de
compra con la unidad, para determinar si el período de garantía está todavía en efecto.
Esta garantía no se aplica a daños causados por accidentes, modificaciones, o uso inadecuado o irrazonable.
Los artículos descartables tales como pilas, fusibles, bulbos de lámparas, tubos flash se excluyen también
de esta garantía.
ACTRON MANUFACTURING COMPANY NIEGA CUALQUIER RESPONSABILIDAD POR PERJUICIOS
INCIDENTALES O CONSECUENTES POR VIOLACION DE CUALQUIER GARANTIA ESCRITA PARA LA
UNIDAD. Algunos estados no permiten la negación de responsabilidad por perjuicios incidentales o consecuentes,
de manera que la negativa anterior puede o no aplicarse a usted. Esta garantía otorga derechos legales
específicos, y usted puede tener también derechos que pueden variar de estado a estado.
NO VALIDA ÉN MEXICO
Actron Manufacturing Company, 15825 Industrial Parkway, Cleveland, Ohio 44135, garantit à l'utilisateur que
cet appareil sera exempt de tout défaut lié aux matériaux ou à la main d'œuvre pendant une période de un (1)
an à compter de la date d'achat d'origine.
Toute unité qui tomberait en panne durant cette période sera réparée ou remplacée, au choix d'Actron, et sans
frais si elle a été retournée à l'usine. Actron demande qu'une copie de la facture d'achat d'origine datée soit
retournée avec l'appareil pour contrôler que la période de garantie est toujours effective.
Cette garantie ne s'applique pas aux dommages causés par accident, modifications ou utilisation inadéquate
ou hors du raisonnable. Les éléments consommables, tels que piles, fusibles, ampoules ou tubes fluorescents
sont également exclus de cette garantie.
ACTRON MANUFACTURING COMPANY REJETTE TOUTE RESPONSABILITÉ POUR DOMMAGES
ACCESSOIRES OU INDIRECTS POUR MANQUEMENT À N'IMPORTE QUELLE GARANTIE ÉCRITE SUR
CETTE UNITÉ. Certains états ne permettent pas le déni de responsabilité pour dommages accessoires ou
indirects, cette clause peut donc n'être pas applicable dans votre cas. Cette garantie vous octroie des droits
légaux spécifiques, et vous pouvez aussi avoir des droits supplémentaires qui varient d'un état à l'autre.
UN (1) AN DE GARANTIE COMPLÈTE