Actron CP7953 User Manual

Full one (1) year warranty, Garantia completa por un (1) año, Un (1) an de garantie complète

Advertising
background image

1

ANALOG HOUR METER - INSTRUCTIONS

METRO ANÁLOGO DE LA HORA - INSTRUCCIONES

MÈTRE ANALOGUE D’HEURE - INSTRUCTIONS

HOUR METER

TO REMOVE BRACKET SPREAD
EARS AND PULL BRACKET BACK

TO INSTALL BRACKET PUSH
IT ONTO HOUR METER.

MOUNTING

BRACKET

RECEPTACLE

INSULATOR

WIRE

RECEPTACLE

This hour meter provides a precise, tamper-proof
record for determining the operating period of an
engine in elapsed hours. It is non-erasable, and
produces the perfect service reminder for pre-
ventive maintenance.

Hour meters are mainly used for monitoring the
running time of off-road vehicles and machinery.
They are useful for recording maintenance time,
warranty time, service records and rental use
time.

PRECAUTIONS

1. Read the entire instructions for your meter

before proceeding.

2. Be sure the meter is suitable for your appli-

cation.

3. It is recommended that the battery ground

cable be disconnected before any electrical
work is performed, especially when install-
ing the hour meter.

4. Route all wiring away from linkages, high

heat or moving parts.

5. Never smoke while working on your vehicle

and always keep a fire extinguisher nearby.
It should be rated for gas/chemical/electrical
fires.

6. Never lay tools on top of the battery or wear

jewelry during electrical work to avoid se-
vere electrical shorts.

INSTALLATION

1. Choose a location to mount the meter.

2. If you are creating a hole, use a 1 3/4” diam-

eter.

3. Disconnect the ground cable from the bat-

tery.

4. Connect a length of 18-gauge insulated cop-

per wire (not included) to a good ground
source. Be sure the grounding surface is a

7. After mounting the meter, connect the re-

ceptacle of the wire from the ground source
(Step 4) to the hour meter’s spade terminal
marked “–”.

8. Connect the receptacle of the wire from the

power source (Step 5) to the hour meter’s
spade terminal marked “+”.

9. Reconnect the battery ground cable. As you

do, watch for sparks and check if the wiring
you worked with is becoming warm. If either
condition is noted, IMMEDIATELY disconnect
the battery ground cable and read the
Troubleshooting section.

TROUBLESHOOTING

1. If, when you reconnected the battery ground

cable, you noticed sparks or any of the wir-
ing becoming warm, check that all connec-
tions are properly located, and insulated from
grounding.

2. If the meter reading does not increase after

more than 6 minutes (1/10 h) of engine run-
ning, recheck connections and make sure
that the receptacles are not crossed and
power is applied to the correct meter termi-
nals.

good ground source as not all metal surfaces
inside the vehicle are well grounded. This
wire should be long enough to reach the hour
meter’s mounting location.

5. Connect another length of 18-gauge wire to

a vehicle circuit where the wire will receive
power whenever the engine is running. This
wire should also be long enough to reach
the hour meter.

6. Place receptacle insulators on each of the

two 18-gauge wires (meter side), strip wire
insulation, attach receptacles to the wires,
and push the receptacle insulators over the
receptacles.

©

2005 Sunpro, a division of SPX

0002-000-2759

FULL ONE (1) YEAR WARRANTY

Sunpro, a division of SPX
15825 Industrial Parkway
Cleveland, Ohio 44135

© 2005 Sunpro, a divsion of SPX

Sunpro, a division of SPX, 15825 Industrial Parkway, Cleveland, Ohio 44135, warrants to the user that this unit
will be free from defects in materials and workmanship for a period of one (1) year from the date of original
purchase.

Any unit that fails within this period will be repaired or replaced at Sunpro’s option and without charge when
returned to the Factory. Sunpro requests that a copy of the original, dated sales receipt be returned with the
unit to determine if the warranty period is still in effect.

This warranty does not apply to damages caused by accident, alterations, or improper or unreasonable use.
Expendable items, such as batteries, fuses, lamp bulbs, flash tubes are also excluded from this warranty.

Sunpro, a division of SPX DISCLAIMS ANY LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
FOR BREACH OF ANY WRITTEN WARRANTY ON THE UNIT. Some states do not allow the disclaimer of
liability for incidental or consequential damages, so the above disclaimer may or may not apply to you. This
warranty gives specific legal rights, and you may also have rights which vary from state to state.

GARANTIA COMPLETA POR UN (1) AÑO

Sunpro, a division of SPX, 15825 Industrial Parkway, Cleveland, Ohio 44135, garantiza al usuario que esta
unidad estará libre de defectos de materiales y mano de obra por un período de un (1) año a partir de la fecha
original de compra.

Toda unidad que falle dentro de este período será reparada o reemplazada a la opción de Sunpro y sin cargo
cuando sea devuelta a la fábrica. Sunpro requiere que se devuelva una copia del recibo original fechado de
compra con la unidad, para determinar si el período de garantía está todavía en efecto.

Esta garantía no se aplica a daños causados por accidentes, modificaciones, o uso inadecuado o irrazonable.
Los artículos descartables tales como pilas, fusibles, bulbos de lámparas, tubos flash se excluyen también
de esta garantía.

Sunpro, a division of SPX NIEGA CUALQUIER RESPONSABILIDAD POR PERJUICIOS INCIDENTALES O
CONSECUENTES POR VIOLACION DE CUALQUIER GARANTIA ESCRITA PARA LA UNIDAD. Algunos
estados no permiten la negación de responsabilidad por perjuicios incidentales o consecuentes, de manera
que la negativa anterior puede o no aplicarse a usted. Esta garantía otorga derechos legales específicos, y
usted puede tener también derechos que pueden variar de estado a estado.

NO VALIDA ÉN MEXICO

© 2005 Sunpro, a divsion of SPX

Sunpro, a division of SPX, 15825 Industrial Parkway, Cleveland, Ohio 44135, garantit à l'utilisateur que cet
appareil sera exempt de tout défaut lié aux matériaux ou à la main d'œuvre pendant une période de un (1) an
à compter de la date d'achat d'origine.

Toute unité qui tomberait en panne durant cette période sera réparée ou remplacée, au choix d'Sunpro, et sans
frais si elle a été retournée à l'usine. Sunpro demande qu'une copie de la facture d'achat d'origine datée soit
retournée avec l'appareil pour contrôler que la période de garantie est toujours effective.

Cette garantie ne s'applique pas aux dommages causés par accident, modifications ou utilisation inadéquate
ou hors du raisonnable. Les éléments consommables, tels que piles, fusibles, ampoules ou tubes fluorescents
sont également exclus de cette garantie.

Sunpro, a division of SPX REJETTE TOUTE RESPONSABILITÉ POUR DOMMAGES ACCESSOIRES OU
INDIRECTS POUR MANQUEMENT À N'IMPORTE QUELLE GARANTIE ÉCRITE SUR CETTE UNITÉ. Certains
états ne permettent pas le déni de responsabilité pour dommages accessoires ou indirects, cette clause peut
donc n'être pas applicable dans votre cas. Cette garantie vous octroie des droits légaux spécifiques, et vous
pouvez aussi avoir des droits supplémentaires qui varient d'un état à l'autre.

UN (1) AN DE GARANTIE COMPLÈTE

© 2005 Sunpro, a division of SPX

Advertising