BBK Performance 1725 - Manual

1994-2004 Ford Mustang V6/V8/Cobra
Cold-Air Induction Systems
#'s 1712/1713/17130/1717/1718/1719/1725
INS-068
Step 1 Remove the entire stock air inlet system from the vehicle by simply unclamping at the throttle body and removing
the bolt attaching the air box to the inner fenderwell area. Disconnect all hoses, wiring, etc., and then tug upwards
firmly on the airbox to disengage from the rubber grommet in the framerail.
*Note: rubber grommets will sometimes stay attached to the bottom of the stock airbox, be sure to remove them
and reinstall into the framerail.
Step 2 Remove the mass-air sensor from the air filter box and attach to the new filter mount using the supplied bolts
and nuts (4) with the electrical plug portion at the top.
*Note: On most models the airbox will need to be
disassembled in order to allow access to mass-air flow
sensor. The airbox will come apart approximately 3 in.
down from where the throttle body inlet hose attaches to
the airbox.
Step 3 Attach the 2 supplied grommet studs to the fender
filtermount with supplied hardware; the studs must be
facing downward to slip into the rubber grommets in the
framerail. (See Diagram)
*Note: Some models come with a large rubber grommet
and separate 3-1/2” dia. tube assembly. If so install the
large grommet into the corresponding hole in the
fenderwell bracket, lightly oil the grommet inside
diameter and carefully slide the 3-1/2” tube through
the grommet.
Step 4 Install the assembled filtermount into the vehicle by pressing the aluminum studs firmly into the grommets
on the framerail then attach at the grommet on the inner fenderwell using stock hardware.
Step 5 Slide the appropriate sized tube coupler over the mass-air sensor and attach with the supplied hose clamp.
Step 6 Slide the other tube coupler over the throttle body end of the inlet tube with supplied clamps and install between
the throttle body and mass-air sensor, align the tube while tightening hose clamps. (On some models, the coupler
attached to the mass-air sensor will be larger than the inlet tube, this coupler is designed to clamp down more
than usual and will provide a smooth transition from the mass-air to the inlet tube.)
Step 7 Attach all tubes, wiring, etc., to the new inlet tube (some models will have hose supplied to adapt the OEM hoses).
Step 8 Install filter from under the fender and clamp tightly into position.
*Note: Filter will not fit through the opening in the engine compartment, therefore it must be installed from
underneath the fender.
I N S T A L L A T I O N I N S T R U C T I O N S
w w w . B B K P E R F O R M A N C E . c o m
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).