BBK Performance 40100 - Manual

INS12 0
2005-2009 FORD MUSTANG
4.0L V-6 HEADERS
PART# 4010-40100
Tools required; Jack, stands, 8mm, 13mm, & 22 mm open end wrenches,
ratchet, swivel, extensions, 13 mm, & 15mm deep sockets, small flat
screwdriver 7/8” open end.
STEP 1 Disconnect negative battery terminal
STEP 2 Disconnect both cables from battery
STEP 3 Remove the bolt that secures the dipstick tube to the driver side
cylinder head and pull the dipstick tube straight up to remove it from
the engine.
STEP 4 Lift the vehicle as high as possible with jack and support with stands.
Unplug all oxygen sensors.
STEP 5 Separate the cat-back system by loosening the 2 nuts on the band
clamp and prying the locking tab up with a small screwdriver while
sliding the clamp towards the rear of the car.
STEP 6 Unplug the coil packs and fuel injectors
STEP 7 Unbolt stock Y-pipe from collectors and remove the Y-pipe from the
car.
STEP 8 Remove any o2 sensors that may be the exhaust manifolds
STEP 9 Remove the stock exhaust manifold and gasket.
STEP 10 Install the oxygen sensors into the BBK headers
STEP 11 Install BBK header and supplied gasket.
STEP 12 Insert and finger tighten the supplied collector studs
STEP 13 Re-install Y-pipe using supplied washers, lock washers and nuts at
collectors.
STEP 14 Re-connect the oxygen sensors
STEP 15 Re-connect negative battery terminal
NOTE:
After driving the car for a few hours it’s always a good idea to check and
re-tighten the header bolts.