Alto-Shaam Hot Carving Shelf 100-HSL/BCS-2S User Manual

Page 4

Advertising
background image

Operation & Care Manual •

3.

The carving shelf, complete with unattached items

and accessories should be checked to ensure all the

following items have been received as standard with

each unit.

4: 1" (25mm) Legs
4: Nylon Screws
1: Cutting Board
2: Lamps
4: Sneeze Guard Mounting Screws

(some models)

Alto-Shaam hot carving shelves are designed for the

purpose of maintaining hot food at a temperature for

safe consumption. The unit must be installed on a level

surface in a location that will permit the equipment to

function for its intended purpose and allow adequate

access for proper cleaning and maintenance.

The carving shelf must not be installed in any area

where it will be affected by steam, grease, dripping

water, high temperatures, or any other severely adverse

conditions.

1.

WHEN THE UNIT IS EQUIPPED WITH A

SNEEZE GUARD

:

Refer to the Service Views located in this manual.

Swing the sneeze guard up to the proper position

and secure each side with the two (2) additional

screws provided. Tighten all four (4) screws to

mount the sneeze guard securely.

2.

The hot carving shelf is designed to be mounted

directly on top of a Halo Heat cook/hold oven or

holding cabinet. The shelf can also be used as a

free-standing unit without the Halo Heat cabinet.

A.

CABINET MOUNTED SHELVES:
Install the four (4) nylon screws in the leg

mounting holes to protect the top surface of the

cabinet and to provide a more stable placement

between the shelf and the cabinet. Do not

install the 1" (25mm) equipment legs. Place the

carvery on top

of the cabinet.

B.

FREE-STANDING SHELVES:
Install the 1" (25mm) legs before operating the

shelf. Failure to install the 1" legs prior to

heating the shelf could result in damage to the

surface on which the shelf is placed, may pose a

potential fire hazard, and nullifies the validity

of the UL listing mark.

3.

Level the appliance from side-to-side and

back-to-back with the use of a spirit level.

I N S T A L L A T I O N

SITE INSTALLATION

N E T W E I G H T

40 lbs

with sneeze guard 45 lbs.

(18 kg)

(20 kg)

C A U T I O N

TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.

D A N G E R

IMPROPER INSTALLATION,

ALTERATION, ADJUSTMENT,

SERVICE, OR MAINTENANCE COULD

RESULT IN SEVERE INJURY, DEATH

OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,

OPERATING AND MAINTENANCE

INSTRUCTIONS THOROUGHLY

BEFORE INSTALLING OR SERVICING

THIS EQUIPMENT.

Advertising
This manual is related to the following products: