BBK Performance 1461 User Manual
BBK Performance For the car
INS162
2011 FORD MUSTANG V6,V8
X-PIPES FOR FULL LENGTHS
PART# 1461,1462,1655,1658
TOOLS REQUIRED-13, 15mm sockets, ratchet, ¾” wrench, 22mm wrench.
STEP 1
Disconnect negative battery cable.
STEP 2
With BBK Full Length headers (part #’s 1642/0/5 or 1633/0/5) installed, lift X-pipe in place.
STEP 3
Line up rear of X-pipe with stock barrel style clamps and slip clamps over reduced end of X-pipe.
STEP 4
Position X-pipe collector flanges up to headers, connect headers and X-pipe with studs supplied
in the header kit.
STEP 5
Adjust position of exhaust system for fitment and clearance. Tighten clamps and collector nuts.
STEP 6
Remove rear O2 sensors from the stock midpipes.
STEP 7
Install rear O2 sensors in the BBK X-pipe.
STEP 8
Connect supplied O2 sensor extension wires to plugs at wire harness at the side of the trans.
Connect the sensors.
STEP 9
Start engine and check for any exhaust leaks.
X-pipe shown installed
Connects to stock rear barrel-style clamps
IMPORTANT- All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.