BBK Performance 2523 - Manual

INS139
2005-up S197
Mustang Rear Control Arms
Part # 2523
Tools required
- 18mm socket, 21mm deep socket, 50mm Torx bit, ratchet, long extension.
Pliers or vice grips.
UPPER ARM
STEP 1 Lift rear of vehicle and support axle on jack stands.
STEP 2 From inside the car, remove rear seat by pushing in on tabs under
seat front, one on each side. Lift seat bottom up and remove from car.
STEP 3 Remove the single 18mm bolt on center of trans tunnel.
STEP 4 Place a jack under one side of the fuel tank to support the weight of
the tank only. DO NOT LIFT THE VEHICLE BY THE FUEL TANK!
STEP 5 From under the car, remove the (2) #50 Torx bolts that retain the gas
tank straps. Let fuel tank hang down onto driveshaft.
STEP 6 Remove two 18mm bolts that retain upper control arm bracket to floor.
Lower the tank slowly. Tank will rest on the driveshaft when lowered.
NOTE The bolt that attaches the upper control arm to the rear end
housing has an arm/flag on one side to keep it from spinning. Be
sure to put your wrench or socket on the 21mm nut that is on the
other side to remove the bolt.
STEP 7 Remove the bolt that holds the upper arm to top of rear end housing.
STEP 8 Remove the bracket and arm from the vehicle.
STEP 9 Remove the 18mm bolt that holds the control arm to the bracket.
STEP 10 Install the BBK upper arm into the bracket using the original bolt and
tighten to 129 ft-lbs.
STEP 11 Install the bracket and arm back into the car and tighten the 2 bolts
that hold the bracket to the floor pan to 89 ft-lbs.
STEP 12 Tighten the BBK arm to the rear end housing using the original nut
and bolt to 129 ft-lbs.
STEP 13 Torque the front bracket bolt (inside the car) to129 ft-lbs. Reinstall
rear seat.
STEP 14 Lift fuel tank back into position and re-secure tank straps with the
original bolts.
LOWER ARMS
STEP 1 Jack up car and support axle on stands. Remove & install arms one
side at a time
NOTE Release the parking brake before moving to STEP 2.
STEP 2 Remove clip for e-brake cable at caliper. Remove cable from
actuating arm. Slide cable out and thru lower control arm. Let the
cable hang.