BBK Performance 2502 - Manual

Gripp Front-End Polyurethane Bushings
(Sway-Bar, Strut Mount Vend-Link)
INS-016
I N S T A L L A T I O N I N S T R U C T I O N S
w w w . B B K P E R F O R M A N C E . c o m
A BBK Company
Step 1 First with the vehicle on firm level ground, open the hood and take off the center nut on the strut itself
(see Photo A). Replace old bushings with new ones and retighten.
Step 2 Next support front of vehicle on jackstands.
! CAUTION !
Use extreme caution under vehicle
Step 3 First remove both front wheels and proceed to take off the factory endlinks as shown in Photo B.
Step 4 Next remove one swaybar bushing at a time and install the new one before going on to the other side.
NOTE
The plastic nut caps on the top of the swaybar mounts will
usually break and you will need to hold the nut with a wrench
Also a light coating of grease will prevent future squeaking.
Step 5 Finally install the new endlink bushings as shown in Photo B and proceed to tighten them until they begin to
compress. (Use caution not to over tighten them.)
Step 6 Place the wheels back on the car and tighten to factory specifications. Then you can lower the vehicle
using caution.
Photo A Photo B
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).