BBK Performance 1723 - Manual

Dodge/Jeep 4.7L
Throttle Body
INS-086
Step 1 Raise hood and disconnect negative (–) battery terminal.
Step 2 Remove air duct from throttle body.
Step 3 Disconnect all hoses, electrical connectors, etc. from the stock throttle body.
Step 4 Disconnect throttle and any other cables attached to the throttle linkage.
Step 5 Remove 3 screws holding throttle throttle body to intake and remove throttle body from vehicle carefully making
sure not to damage the factory reusable gasket.
Step 6 Transfer the TPS and the IAC valve from the stock onto the BBK throttle body using the factory hardware and
gasketing.
Step 7 Installation is the reverse of disassembly from the vehicle. Make sure the gasket is seated properly on the intake
and is free of any debris etc. Take great care in reinstalling the stock mounting hardware into the manifold,
the screws self-tap into the plastic and must follow the same thread upon installation. If over tightened the
plastic will strip, damaging the plastic intake manifold.
Step 8 After reinstalling the negative (–) terminal, start the vehicle using only the key (no accelerator) and allow to idle
until up to full coolant operating temperature; this will allow the computer to establish the appropriate idle speed
for the new throttle body.
I N S T A L L A T I O N I N S T R U C T I O N S
w w w . B B K P E R F O R M A N C E . c o m
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).