DAVIS CarChip Fleet Installation (8241, 8245) - Manual

1
CarChip Fleet & CarChip Fleet with
Alarm Installation Instructions
This manual provides installation instructions for CarChip Fleet ( # 8241 ) and
CarChip Fleet with Alarm ( # 8245 ). CarChip Fleet with Alarm provides an
audible warning to the driver whenever safe driving limits are exceeded.
Refer to the DriveRight Fleet Management Software’s (FMS) Getting Started
Guide, User’s Manual, and the software’s online Help for the additional infor-
mation necessary to set up and use your CarChip Fleet or CarChip Fleet with
Alarm.
Note: The DriveRight FMS User’s Manual is in the Adobe Acrobat file “User’s Manual.pdf”
located in the program folder.
Before Installing CarChip
Before installing CarChip Fleet or CarChip Fleet with Alarm in your vehicle,
we recommend that you add the device to the database in the DriveRight Fleet
Management Software (FMS) and check the CarChip settings.
1. Connect CarChip to your computer. See instructions on page 3.
2. Add the CarChip to your DriveRight FMS database.
Note: Refer to the DriveRight FMS Help or User’s Manual for instructions on using DriveR-
ight FMS.
3. In DriveRight FMS, verify the following CarChip settings and change if
necessary:
• Time and date
• Engine performance data parameters
• Speed bands
• Acceleration limits and deceleration limits
• LED State (Controls both the LED and alarm on CarChip Fleet with Alarm)
4. Use the Clear CarChip Memory command in the DriveRight FMS CarChip
menu to clear the device’s memory. This step ensures that none of the man-
ufacturing test data remains when you put your CarChip into service.
Configuring CarChip Fleet with Alarm
1. Select the Set CarChip LED State command in DriveRight FMS CarChip
menu. The Set CarChip LED State command controls the alarm and LED
functions.
2. Select Enable to turn ON the alarm and LED, or select Disable to turn OFF
the alarm and LED.
DriveRight
®