DAVIS Weather Wizard III - Manual (Page 27)

Using the Console Functions
Page 26 Weather Wizard III
To Clear an Alarm
1. Since the function triggering the alarm is already on the display, simply press ALARM
once or twice to get the desired alarm setting (high or low) for that function.
If more than one alarm is sounding, wait until the function you want to clear
appears before you press ALARM.
2. Press and hold down CLEAR until the display shows a series of dashes.
C LEARING AN A LARM
3. Press any key to exit.
Note: Each alarm setting is independent of every other. For instance, clearing the high inside tempera-
ture alarm does not clear the low inside temperature, high outside temperature, or low outside
temperature alarms. You must clear each alarm individually.
T OTAL C LEAR
The total clear function automatically clears all of the high and low readings at
the same time.
The following functions are reset by the total clear function:
• High and Low Inside Temperatures
• High and Low Outside Temperatures
• High Wind Speed
• Low Wind Chill
The following functions are not reset by total clear:
• Time
• Date
• Daily and Accumulated Rainfall
• Alarm Settings
To Use Total Clear
1. Display any function except highs and lows, alarms, or rainfall.
2. Press CLEAR and hold it down.
The unit will beep and the display will flash seven times and then stop. When
this happens, the high and low functions listed above have been cleared.
MPH
N
NE
SW
NW
SE
E W
S
LOW
WINDCHILL
ALARM