DAVIS DriveRight Installation - GD (All DriveRight Models) User Manual
DAVIS For the car
Advertising
Table of contents
Document Outline
- DriveRight Installation Manual, Rev B
- 1. Contents of Package
- 2. Introduction
- 3. Planning Your Installation
- Step 1. Display Mounting Options
- Step 2. +12V Power and Ground Connections
- Step 3. Sensor Installation
- Rear Wheel Drive
- Front Wheel Drive
- Rear Wheel Drive
- Front Wheel Drive
- Step 5. Wire Routing
- Step 6. Wire Connections
- Step 7. Initial Test
- 1. Insert the battery (2) into the display as shown in Figure 24. (If your battery is already ins...
- 2. Press and hold MODE for 3-5 seconds until the last correct code screen appears.
- 3. With the ignition off, insert the DriveRight display cable into the harness cable connector an...
- 4. Roll the car forward slowly so the driveshaft or CV joint hub complete at least one complete r...
- 5. Road test the DriveRight by driving around and observing the readings. You will need two peopl...
- 4. Troubleshooting Guide
- 1. White sensor wire is connected to the white wire of the harness cable.
- 2. Black sensor wire is connected to the black wire of the harness cable.
- 3. Sensor leads should be protected with split tubing and tie wrapped in place. Wires should be r...
- 4. Unswitched +12V from your vehicle is connected to the red wire of the harness cable.
- 5. Ground connection from your vehicle is connected to the black wire from the sensor.
- 6. Sensor installation is completed as directed.
- 7. Display is installed and tested as directed.
- Answers to Common Questions
- Sensor Wire Continuity Test
- 1. Unplug harness cable.
- 2. Use an multimeter or continuity tester to probe Pins 2 and 3 on the harness connector.
- 3. Roll vehicle forward.
- 4. If no short is indicated, check the wiring carefully for breaks or loose connections. Probe be...
- 5. Check the butt connectors carefully for loose connections by probing across the butt splice fo...
- 6. Check the sensor wires for nicks or other signs of damage, remove and replace suspect sections...
- 5. Warranty & Repair Information