AMX Wireless Compact Flash Card NXA-WC80211GCF - Manual (Page 6)

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
3/11
©2011 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2255-07 REV: G
5. Toggle the Default Key field until the you’ve chosen a WEP Key value (from
1-4) that matches what you’ll be using on your target WAP250G. These WEP
Key identifier values must match for both devices.
6. With the proper WEP Key value displayed, press the Generate button to
launch the WEP Passphrase keyboard.
This keyboard allows you to enter a Passphrase (such as AMXPanel) and then
automatically generate a WEP key which is compatible only among all Modero
panels.
7. Within this on-screen WEP Passphrase keyboard, enter a character string or
word (such as AMXPanel) and press Done when you have finished.
As an example, enter the word AMXPanel using a 128-bit hex digit encryption.
After pressing Done, the Current Key field displays a long string of characters
(separated by colons) which represents the encryption key equivalent to the
word AMXPanel.
Record the Current Key string value for later entry into your WAP’s WEP Key
field (typically entered without colons) and into other communicating panel’s
Current Key field.
8. Leave the Authentication field reading Open (default).
9. Press the Save button to store this configuration and return to the previous
page.
10. Press the Back button to navigate to the Protected Setup page and press the
Reboot button to save any changes and restart the panel.
Remember that you will need to navigate to the System Settings page and configure
the connection to a target Master.
page 6 of 6