GReddy e-Manage: Ignition Adapter User Manual
Ignition adapter, 点火信号 アダプタ
Yellow
Yellow
Black
Yellow
To ECU
Ignition Signal CH-1 IN(Bl/W)
Ignition Signal CH-2 IN(O/W)
Ignition Signal CH-4 IN(P/W)
Ignition Signal CH-3 IN(Y/W)
Ground(B)
Yellow
Yellow
Yellow
Ignition Signal CH-5 IN(PI/W)
Ignition Signal CH-6 IN(LB/W)
Ignition Adapter1
《How to Connect》
1. Connect the Yellow wires to the e-manage Ignition Input Channels.
2. Connect the Black wire to Ground.
◎This adapter is to remove the check engine light caused from wiring the
ignition harness on the Nissan NEO straight six(ER34, WGNC34).
黄
黄
黒
黄
ECUへ
点火信号 CH-1 IN(青/白)
点火信号 CH-2 IN(橙/白)
点火信号 CH-4 IN(紫/白)
点火信号 CH-3 IN(黄/白)
アース(黒)
黄
黄
黄
点火信号 CH-5 IN(桃/白)
点火信号 CH-6 IN(水色/白)
点火信号 アダプタ1
《配線方法》
1. アダプタの黄線を各点火信号入力線(ECUとe-manageの間)に配線します。
2. アダプタの黒線をアースに配線します。
◎NEOストレート6(ER34,WGNC34)の車両等で、e-manageを配線した場合、
車両側のチェックランプが点灯するのを回避します。