Monoprice 6529 MHP-100 - Manual (Page 2)

2 of 8
Note: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
‡ stud finder ("edge to edge" stud finder is recommended)
‡ phillips screwdriver
‡ drill with 1/4", 3/8" drill bits
Table of Contents
Parts List .............................................................................................................................................................................. 3
Installation to Wood Joist Ceiling .......................................................................................................................................... 4
Installation to Concrete Ceiling ............................................................................................................................................. 5
Installation of Extension Column ........................................................................................................................................... 6
Removing the ceiling plate from the flush mount assembly ............................................................................................. 7
Put out columns and install them to the projector .................................................................
Install the bottom plate with projectto ceiling plate .................................................................
............................................. 7
............................................. 8
Angie adjustment and management .......... .......... ................................................................. ............................................. 8
WARNING
‡ Be sure to read this entire manual thoroughly and you fully understand all the instructions and warning before
attempting to begin your installation.
‡ This product should only be installed by someone who has a basic knowledge of buiding construction,in stallations
and fully understands these instructions.
‡ Make sure that the supporting surface will safely support the combined load of the mount, the display and all
attached hardware and components.
‡ The maximum load capacity is 50 pounds.
‡ Always have someone assist you to lift and position your equipment.
‡ Tighten screws and bolts firmly, but do not over tighten. Over tightening can damage the items and greatly reduce
their ability to hold. Please refer to suggested torque values where applicable in these instructions.