Monoprice 6530 MHP-40 - Manual (Page 8)

fig1
fig 2
8 of 8
pull cables up and through conduit .
Wire Management
Tilt Adjustmentd
‡ Do not lift more weight than you can handle. Use
additional man power or mechanical lifting equipment
to safely handle placement of the screen.
WARNING
Insert two for 200x200 & 200x100 VESA patterns appro-
priate sized bolts into the top two mounting holes
on the back of your display as shown in fig.1 Leave
approx. 1/4" of exposed thread.
Lift the display and hook it on to the display mount-
ing plate by lowering the exposed portion of the top
screws down the notches on the top edge of the
plate for a 200x200 pattern or into the key hole.
Once in position, attach the bottom two for a
200x200 pattern bolts to secure the display to
the mounting plate as shown in fig.2
fig.1
fig.2
top screw
0.25" ( D . E .
F . G or H)
‡ Do not remove or loosen screw
while the mount is in use. Doing
so may cause the screen to fall.
Adjust tension knob on side of mount as shown in fig.
1 to desired tension to balance your screen size
and weight.
The tension knob, without changing the bracket tension,
can be pulled out, away from the bracket and turned
independently of the knob post for readjustment as
shown in
fig 2
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of -5° forward or +15°backward
.
‡ Be careful not to pinch fingers when opening and
closing mount from the wall.
CAUTION
WARNING