Monoprice 7470 MED-028 - Manual (Page 3)

WARNING
• Make sure that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
• Tighten wood screws firmly, but do not overtighten. Overtightening can damage the screws,
greatly reducing their holding power.
• Make sure that mounting screws are anchored into the center of the studs. Use of an “edge to
edge” stud finder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster
into studs. Installers are responsible to provide hardware for other types of mounting situations.
WOOD STUD WALL MOUNTING: 1a
Wall plate can be mounted to two studs. Use a stud finder to locate the edges of the studs. Use of an
edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each
stud’s center.
Place wall plate on wall as a template. And mark the center of the four mounting holes. Make sure that the
mounting holes are on the stud centerline.
Drill four 1/8” (3mm) dia. Holes 1.2” (30mm) deep, secure it using four lag bolts (W-A)
as shown in fig. 1.1.
•
•
• and four M6 washers
(W-C)
Stud
W-A
W-C
fig. 1.1
3mm
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8” of actual
concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar
joints! Be sure to mount in a solid part of the block, generally 1” minimum from the side of the
block. It is suggested electric drill on slow setting is used to drill the hole instead of a hammer
drill to avoid breaking out the back of the hole when entering a void or cavity.
• Installer must verify that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
SOLID BRICK AND CONCRETE BLOCK MOUNTING: 1b
3
• Use the Wall Plate as a template to mark 6 holes locations on the wall. Four in the top row slots and two
more in the bottom row, as shown in fig.1.2.
• Pre-drill these holes with a 10mm masonry bit to at least 60mm in depth. Insert a Concrete Anchor (W-B)
into each of these holes. Attach the Wall Plate to the wall using 6 Lag Bolts (W-A) and 6 M6 Washers (W-C),
as in fig.1.3.
fig. 1.2 fig. 1.3
•
•
• and supporting spacer
and
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the
screen.
Place screen face side down. Place adapter bracket and supporting spacer on the back of screen, align
to holes, as shown in fig.2.1.
Attach the adapter brackets to the back of the screen using the appropriate
combination of screws, washers, and spacers, as shown in fig.2.2, fig.2.3, fig.2.4 fig.2.5.
2 Installing Adapter Brackets
4
W-A
W-B W-C
NOTE: For flat back screens proceed to step 2-1. For bump-out or recessed back screen skip to
step 2-2.
fig. 2.1