Monoprice 8097 MDA03-113 - Manual (Page 4)

6 5
fig. 4.1
• To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen.
• Place screen face side down. Place
dapter racket on the back of screen, align to holes, as shown in fig.2
• Attach the adapter bracket to the back of the screen using appropriate combination of washers and screws. as
shown in fig.2.2
the a b .1
2 Installing Adapter Bracket
fig. 2.2 fig. 2.1
fig. 3.1
• Tighten the screws till the display angle can be fixed, then push or pull from top or bottom of screen to adjust
the display to the desired angle.
• The pitching angle can be adjusted between -20° ~ +20°, swivel: ±90°, pivot: ±10°, as shown in fig.4.1.
4 Pitching angle adjustment
Maintenance
Once you have mounted the bracket and the flat screen, check that they are sufficiently secure and safe to use.
You should check whether screws are fixed well each two months. If you have any doubts regarding the
installation, please consult our retailer or service department for detail.
fig. 1.2
W-A
W-B
For VESA 75x75 / 100x100 mm compliant
fig. 1.3
+20°
-20°
±90°
±90°
M-E
M-E
• Place the adapter bracket mounted display onto the plate of articulated arm assembly, as shown in fig 3.1.
• Adjust the display level, and then tighten the safety screws with 3mm allen key(M-E). Do not over tighten!
as shown in fig 3.1.
Important: Make sure the brackets mounted display is correctly mounted and the safety locking screws are
locked safely before loosening the display.
3 Installing the Display
M-A
M-B
M-C
M-D
+10° -10°