Monoprice 7845 MUA-46 - Manual (Page 7)

7 of 7
• Do not remove or loosen screw while the mount is in use. Doing so may cause the screen to fall.
WARNING
Note:
Make sure cords have enough slack to allow
full movement of the arm. Route cords inside
F
arm slots of wall arm assembly ( AA) as shown
in fig.F.1. For demonstration purposes, the wall
has been omitted from the image.
Cable Management
Adjust tension knob on side of mount as shown in fig
.
E.1to desired tension to balance your screen size
and weight.
The tension knob, without changing the bracket tension
,
can be pulled out, away from the bracket and turned
independently of the knob post for readjustment as
shown in fig.E.2.
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of -5° forward or +15°backward .
E
• Be careful not to pinch fingers when opening and
closing mount from the wall.
CAUTION
fig.F.1
fig. E.1
fig. E.2
top screw
1. Insert two M8x15mm screw bolt
and two metal washers into swivel box
on Assembly Adapter Plate as above
shown.
Leave approx. 1/4" of exposed thread.
2. Lift the display and hook it
over the mounting head by lowering
the exposed portion of the top screws
down the open key slots.
3. Once in position, attach the bottom
two M8x15mm screws and two Iron
washers to secure the display to the
mounting head using M5mm Allen
Wrench.
Attach Assembly Adapter Plate to Assembly Arm D