Monoprice PID 8122 HDMI Extender Using Cat5e or CAT6 Cable Extend Up to 328ft - Manual (Page 2)

Extend HD AV to 100m over one Cat5e/6 CABLE
１
Extend HD AV to 100m Over One
Cat5e/6 Cable
Dear customer
Thank you for purchasing this product. For optimum performance and safety,
please read these instructions carefully before connecting, operating or adjusting
this product. Please keep this manual for future reference.
1.0 INTRODUCTION
The Extender is based on the HDBaseT technology. It extends your HD display with
the resolutions of 1080p/60Hz up to 330 feet (100 meters) away from your HDMI or
DVI-D source using one CAT5e/6 cable. Built-in IR extender function allows IR
remote control of Source devices from remote viewing location by sending IR
commands received in the vicinity of the Display back to the Source devices.
1.1 FEATURES
 Support HDCP
 Support uncompressed HDMI signal.
 Enables HDMI10.2 Gbps over a single 100m Cat5e/6 cable.
 Supports 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth.
 Support 1080p@60Hz@48bit pixels
 Support 3D pass-through.
 Support CEC pass-through.
 Supports uncompressed audio such as LPCM.
 Supports compressed audio such as DTS Digital, Dolby Digital（including
DTS-HD and Dolby True HD）.
 Built-in IR extender function allows IR remote control of Source devices from
remote viewing location by sending IR commands received in the vicinity of the
Display back to the Source devices.
 CAT5e/6 cable follows the standard of IEEE-568B.