Monoprice 8682 XBOX-01 - Manual (Page 3)

4 3
• Use the wall plate as a template to mark four holes locations on the wall as shown in fig.1.2. Make sure
the wall plate is level.
• Pre-drill these holes with a 6mm masonry bit to at least 40mm in depth. Insert a concrete anchor (W-B)
into each of these holes. Attach the wall plate to the wall using four screws (W-A) as shown in fig.1.3.
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of
1-3/8” of actual concrete thickness in the hole to be used for the concrete anchors.
Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally
1” minimum from the side of the block. It is suggested electric drill on slow setting
is used to drill the hole instead of a hammer drill to avoid breaking out the back of
the hole when entering a void or cavity.
• Installer must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
WARNING
• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
• Tighten screws firmly, but do not over tighten. Over tightening can damage the
screws, greatly reducing their holding power.
• Make sure to have a minimum of 1/3" thickness for the wood wall.
fig. 1.1
• Place wall plate on wall as a template. And mark the center of the four mounting holes.
• Drill four 1/12” (2mm) dia. Holes 3/5” (15mm) deep. Secure the wall plate using four screws (W-A) as shown
in fig. 1.1.
WOOD WALL MOUNTING: 1a SOLID BRICK AND CONCRETE BLOCK MOUNTING: 1b
fig. 1.3 fig. 1.2
W-B
W-A
W-A