ALK Technologies Pocket PC 6 Bluetooth - Manual (Page 29)

- 27 -
Favourites
Tap the Favourites tab to open your List of
Favourite Addresses.
To change the assignment of your work or
home address, highlight your choice on the list
and then tap either Work or Home.
To edit an address, highlight it and tap Edit.
Then make your changes in the Edit Address
screen and click Next. Note: POI’s cannot
be edited, you will get a “No matches found”
error message if you try.
POIs
Tap Enabled to enable POI Alerts. CoPilot
will then alert you with voice prompts to the
presence of points of interest as you approach
them. You can use the drop-down pick list to
set how far away you’ll be when you receive
the alerts. In the list of POI categories, select
which types of POIs should be reported.
Move the slider bar at the bottom of the
screen to limit alerts to POIs right on your
route or to include POIs that are nearby.
To delete a favourite, highlight it and tap Delete One. To delete all favourites, tap
Delete All.
NOTE: When your favourites list is filled (50), each new address will
replace the address that has been inactive for the longest period of time.
Modes Menu
CoPilot has three modes of operation on the Pocket PC. Tap Menu > Mode to
select Guidance, Walking, or Planning Mode.
Guidance Mode
In Guidance Mode, you enter one or more
destinations, then tap the Start Driving
button to start driving and receive guidance.
This mode provides you with on-screen and
spoken driving directions and other
information relevant to your trip, such as
estimated time of arrival and distancve to the next stop.
To receive driving directions and other data, you must have a GPS receiver
attached to your Pocket PC and the receiver must be in a good position to
receive signals. Also, Receiving must be turned on in the GPS menu.
Walking Mode
Take CoPilot with you wherever you go! Walking Mode provides an as-the-
crow-flies distance and direction line to your destination, directions that are
perfect for walking. A GPS receiver must be attached and receiving signals.
Planning Mode
Planning Mode lets you use your Pocket PC as a pre-trip planning tool or easy-
to-use reference guide. Planning Mode lets you view static maps and directions
without the need for a GPS receiver.
Trip itineraries you create in Planning Mode can be saved and then loaded in any
mode at a later time (generate directions, then select Save Trip As from the
Tools menu).
Box Zoom — This option is selected by default. It enables you to zoom into an
area on the map by drawing a box around it with the stylus.
Drag Map — Selecting Drag Map lets you use the stylus to drag the map in any
direction to a desired location. Place the stylus on the map and move it across the
screen.
Map
Data areas that are currently downloaded to your
mobile device are shown at the bottom of this
screen.
Options in the Map tab are:
Mile — Use miles as the unit of distance.
KM — Use kilometers as the unit of distance.
Heading Up — The map display will always track
your position moving upward.
North Up — The map display will always maintain
north at the top as you drive.