Auto Page RF-302 - Manual (Page 11)

RF-302
9
Enter the programming mode on vehicle #1 and push the ON/OFF
button on the transmitter for Vehicle #1. The alarm siren will respond
with a confirming chirp. Within five (5) seconds, push the AUX. button on
the transmitter for Vehicle #2. The alarm siren will respond with a
confirming chirp. Both transmitters are now programmed to Vehicle #1.
VEHICLE #2
Enter the programming mode on Vehicle #2 and push the AUX. button
on the first transmitter used for Vehicle #1. The alarm siren will respond
with a confirming chirp. Within five (5) seconds, push the ON/OFF button
on the second transmitter that had been previously programmed on
Vehicle #1. The alarm siren will respond with a confirming chirp. Both
transmitters are now programmed to Vehicle #2.
NOTE: Here, the first transmitter is assumed to be the primary
transmitter of Vehicle #1, and the second transmitter is assumed to be
the primary transmitter of Vehicle #2.
VEHICLE #1 VEHICLE #2
TRANSMITTER #1 ON/OFF BUTTON AUX. BUTTON
TRANSMITTER #2 AUX. BUTTON ON/OFF BUTTON
2. THREE VEHICLE OPERATION
Three vehicle operation is accomplished in the same manner as two
vehicle operation. Use the chart below to program three vehicles to
operate from one transmitter.
VEHICLE #1 VEHICLE #2 VEHICLE #3
TRANSMITTER #1 ON/OFF BUTTON AUX. BUTTON BOTH BUTTONS
ON/OFF BUTTON BOTH BUTTONS AUX. BUTTON
TRANSMITTER #2 BOTH BUTTONS ON/OFF BUTTON AUX. BUTTON