Outback Power Systems GS8048 Quick Start Guide - Manual

> 90% (blinks if charge parameters are met)
Color
Red
Yellow
Yellow
Yellow
Green
≥ 80%
≥ 70%
≥ 60%
≥ 60% off, < 60% solid, < 50% blinks
Battery State-of-Charge
FNDC LED Indicators
Components
900-0153-01-00 Rev A.vsd\Page-1\2013-01-17
©2012 OutBack Power Technologies. All Rights Reserved.
MATE3 Programming
IMPORTANT:
Programming should be done by a qualified installer who is trained on programming inverter power systems. Failure to program accurate parameters for the
system could potentially cause equipment damage. Damage caused by inaccurate programming is not covered by the limited warranty for the system.
Contact Technical Support:
Telephone: +1.360.618.4363
Email:
[email protected]
Website: www.outbackpower.com
IMPORTANT:
Not intended for use with
life support equipment.
AC Source Utility Grid, or
AC Generator
Main Electrical Panel
(or overcurrent device for
the AC source)
Electrical Distribution Subpanel
(Load Panel)
Battery Bank
Photovoltaic (PV) Array
(with PV Combiner Box [PV8 or PV12])
Customer-Supplied Components
Charge Controller FLEXmax 80*
FLEXmax 60*
Optional OutBack Components
PV Combiner Box
PV8
PV12
*Including appropriate Mounting Bracket.
Inverter/Charger
GS Load Center
System Display
and Controller
MATE3 (FW-MB3
mounting bracket)
Communications
Manager
HUB10
HUB 4
GS8048
FLEXnet DC Monitor (FNDC)
Surge Protector
Remote Temperature Sensor (RTS)
Radian System Products
Major Components
GSLC175-PV-120/240
Communication
Manager
(HUB10)
MATE3
System
Display and
Controller
GS8048 Inverter/Charger
GS Load Center
(GSLC)
FLEXmax 80
Charge Controllers
(x2) (Optional)
RADIAN Series
Note: For automatic generator
start features see the MATE3
manual for details.