Outback Power Systems FLEXpower TWO Quick Start Guide - Manual

Components MATE3 Programming
IMPORTANT:
Programming should be done by a qualified installer who is trained on programming inverter power systems. Failure to program accurate parameters for the
system could potentially cause equipment damage. Damage caused by inaccurate programming is not covered by the limited warranty for the system.
AC Source Utility Grid, or
AC Generator
Main Electrical Panel
(or overcurrent device
for the AC source)
Electrical Distribution Subpanel
(Load Panel)
Battery Bank
Photovoltaic (PV) Array
(with PV Combiner Box)
Customer-Supplied
Components
Contact Technical Support:
Telephone: +1.360.618.4363
Email:
[email protected]
Website: www.outbackpower.com
IMPORTANT:
Not intended for use with
life support equipment.
> 90% (blinks if charge parameters are met)
Color
Red
Yellow
Yellow
Yellow
Green
≥ 80%
≥ 70%
≥ 60%
≥ 60% off, < 60% solid, < 50% blinks
Battery State-of-Charge
FNDC LED Indicators
Phase Active Error
DC
AC IN
AC OUT
Red Yellow
Yellow
Yellow
Red
Red
Surge Protector LEDs
LED Indicators on the Inverter
Inverter Status LED Indicators
Green
Yellow
Red
Inverter on (solid) or standing by (flash)
AC source in use (solid) or standing by (flash)
Inverter error or warning (see manual)
Green
Yellow
Red
12.5 Vdc or higher
11.5 to 12.4 Vdc
11.4 Vdc or lower
Color
Battery Status LED Indicators
25.0 Vdc or higher
23.0 to 24.8 Vdc
22.8 Vdc or lower
50.0 Vdc or higher
46.0 to 49.6 Vdc
45.6 Vdc or lower
12 V Inverter 24 V Inverter 48 V Inverter
Note: For automatic generator
start features see the MATE3
manual for details.
900-0152-01-00 Rev A.vsd\Page-1\2013-01-17
©2012 OutBack Power Technologies. All Rights Reserved.
Inverter/Chargers
(x2)
AC Enclosure Box FW500-AC
DC Enclosure Box FW500-DC
System Display and
Controller
MATE3
MATE2
Communications
Manager
HUB10
HUB4
FX Series
VFX Series
GTFX Series
GVFX Series
GFX Series
FLEXnet DC Monitor FNDC
Surge Protector FW-SP-ACA
Remote Temp Sensor RTS
FLEXpower System Products
Major Components
AC Bypass
Assembly
FW-IOBD-120/240VAC
FW-IOBD-120VAC
PNL-175-DC
PNL-250-DC Inverter Circuit
Breaker
PV8
PV12
Charge Controller FLEXmax 80
FLEXmax 60
Optional OutBack
Components
PV Combiner Box
Balancing
Transformer
FW-X240