Pop & Lock PL1300H3T - Manual

1.
Lower the tailgate and remove the
center 8 MM mounting bolt holding the
handle and bezel.
Loosen the other two bolts 3/8” to 1/2”.
Note: Bedliner panel may have to be removed.
2.
Close the tailgate and carefully pull the
bezel away from the tailgate working
against the three spring clips.
3.
Turn the bezel around and pull the metal
attachment plate out of the mounting
boss.
Push the supplied mounting insert into
place as shown.
4.
Place the POP&LOCK into the lower
right hand corner of the bezel .
Contents:
Lock Assembly, 2 keys
Mounting Insert
6 MM Hex Bolt
6-32 Flat Head Screw
Instructions, Warranty Card
Tools Required:
10 and 13 MM Socket
Phillips Head Screw Driver
Tech Support:
Call 1-800-342-5911
5.
Turn the bezel around and insert the
6-32 screw as shown. Tighten it to secure
the POP&LOCK in place making sure that it
fits tightly in the corner of the bezel.
Do not over tighten the 6-32 screw.
6.
Tilt the bezel down, pull the handle as far
as it will go out of the tailgate and slide the
bezel over it. Push the bezel in until the
spring clips snap into the tailgate.
Insert the supplied 6 MM bolt in the center
mounting hole and tighten (do not over-
tighten screw), then tighten the two 8 MM
mounting bolts, making sure that the
handle is straight.
Close latches and test lock for smooth
operation - see Tech Note attached
Installation Instructions Tailgate Lock PL1300, PL1300H3T & PL1300R
Chevy Silverado/GMC Sierra 1500 ‘07 new body style - up, 2500/3500 ‘08- up
Hummer H3T 2007 - up
For the latest instructions please
visit www.popandlock.net
1-16-2012