Pure Contour i1 Air - Manual (Page 13)

11
Display
Switching between Sleep, Standby and On
Contour has three power modes, Standby, Sleep and On. In Standby, Contour
uses minimal power. In Sleep mode, Contour remains connected to the wireless
network and waits for a source to be selected.
To enter Sleep mode, press Standby. Contour will automatically enter Sleep mode
after 15 minutes if it does not receive any audio from AirPlay or a docked iPod/
iPhone/iPad.
Once in Sleep mode, press Standby to switch to On.
To enter Standby, press and hold Standby for four seconds on Contour, or the
remote until STANDBY is displayed. After two seconds, Contour will enter Standby
and the current time will be shown on the display. Press Standby to switch straight
to On. Contour will pause and then return to the state that Contour was in before
Standby.
Source
indicators
Alarm set
Volume
Sleep timer
set
Busy
indicator
Snooze indicator
Scroll indicator Scroll indicator
Critical firmware
problem indicator
Text area
Repeat all
indicator
Repeat once
indicator
Shuffle
indicator
Network status icons
See page 12.
Contour_i1_Air_manual_Aus_v1.indb 11 7/29/2013 4:29:52 PM