Pure Evoke-2 - Manual (Page 12)

9
Changing the DAB display mode
EVOKE-2 has six DAB display modes which enable you to view parts of the broadcast DAB data on the bottom line of
the display.
Press the Display button and repeat to cycle through the six different display modes.
Scrolling text The default mode, displays scrolling text messages which accompany the audio, where available.
Program Type A label describing the type of content being broadcast by the service.
Multiplex name Displays the name of the multiplex in which the current service is found, see Guide to Digital Radio
on page 14 for more information on multiplexes.
Date and time Displays the date and time obtained from the current multiplex.
Channel Displays the channel identifier and frequency for the station to which you are tuned, see Guide to
Digital Radio on page 14 for more information.
Mode Displays the mode of the current service, Stereo or Mono and the data rate at which the audio
signal is being transmitted. This rate is set by the broadcaster to suit the type and quality of
material being transmitted.
Signal quality Displays the signal quality for the signal to which you are tuned. As a guide values from 85 to 100
indicate good reception, 70 to 84 borderline reception and 0 to 69 poor reception. You can attempt
to improve this signal quality by adjusting your aerial position using the DAB Tuning aid described
on page 12.
Adjusting the volume and tone
Once you have tuned your EVOKE-2 as explained above you can adjust the volume and tone to your preferred levels.
You use the Volume and Tone controls to adjust these levels.
1. Adjust the volume level using the volume control.
2. Adjust the tone level from low (more bass) to high (more treble).