Rosendahl mif 4 - Manual (Page 11)

- 11 -
7. Setup utility
The firmware version installed in your mif 4 is displayed for two
seconds every time the unit is powering up.
Please visit www.rosendahl-studiotechnik.com and download the
utility software "mif4 setup 2.1" available for Mac OS X and
Windows.
If your mif4 unit is running an earlier firmware version (1.0) please
connect the unit to a USB port while holding down both keys.
This will enter bios update mode indicated by both keys illuminated
red and the LED display blanking.
Now start the software and select the midi I/O ports. In Windows XP
you must select the USB audio device, Vista or Windows 7 will list
mif4.
Press the "Update firmware" buttom to start the update process.
Do not disconnect the unit during firmware programming.
When the unit is connected in normal operation mode the mif4 setup
utility allows you to configure parameters like a unique MMC ID,
display brightness, display blanking options and infinite flywheel
mode.
Settings are stored non volatile