Wixey WR510 Type 2 PLANER READOUT - Manual (Page 2)

2
2- Position the Readout assembly
Although the WR510 Planer Readout will function properly mounted many ways, it is recommended that the
foot of the frame is mounted level to or slightly above the surface of the planer table of your planer ( FIG 5 and
FIG 6). It is very important that the foot is never lower than the planer table as it will cause calibration problems
(see trouble shooting in section 10)
Most planer models have a portion of their base casting that can support a leveling screw as shown in FIG 7.
Typically the frame of the Planer Readout will align with the edge of the side cover as shown in FIG 8. See FIG
9 for aligning the frame with the Delta model 22-580 and FIG 10 for the Dewalt Model DW735
FIG 5 FIG 6
FIG 7 FIG 8