AMX Metreau Numeric Audio Keypad DAS-MET-NUM - Manual (Page 2)

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
1/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1122-02 REV: A
Mounting Procedures
AMX recommends mounting Metreau keypads in standard U.S.-style decora
wallboxes:
• Conduit box should meet NEC specs (section 370)
• Minimum internal clearance of (HWD) 2-5/8" x 1-3/4" x 1-5/8".
Note: Before touching the device, discharge the static electricity from your
body by touching a grounded metal object.
Wallbox Mounting
1. Use the cutout dimension for the wallbox to cutout the install surface.
2. Connect the AxLink connector (or SWT cable connectors) to the rear of
the keypad.
3. Place the Mounting Plate on the wallbox; align the screw holes with the
mounting holes and fasten the Mounting Plate to the wallbox using the
screws supplied.
Note: Do not overtighten the screws when mounting the Mounting Frame. The
device should be flush with mounting surface.
Mounting Dimensions
FIG. 4 provides detailed dimensions for the 13-button Metreau keypads.
Programming
SWT-only Metreau keypads (DAS-MET-6SRC and DAS-MET-NUM) are
configured via the Tango Audio Controller. Refer to the Tango Audio Controllers
Operation / Reference Guide for details.
Additional Documentation
Refer to the Metreau Keypads Operation/Reference Guide (available online
www.amx.com) for additional information on configuration, programming and
using the Metreau keypads.
FIG. 4 Mounting Dimensions - DAS-MET-NUM