Checkers Cross-Link Protector Bridge - Manual

HEAVY DUTY
PROTECTOR BRIDGE
ASSEMBLY:
• Inspect areas for safety hazards
• Attach Cable Protectors with
with Cross-Link Base Connector
• Insert cables into Cross-Link Base
Connector channels
• Place Cross-Link Bridge on top of the
Cross-Link base connector
• Press with foot to secure bridge to base
• Test installation for intended use
• Periodically inspect installation
CHANNEL CAPACITY:
LOAD CAPACITY:
The Cable/Hose Protection System has different load supporting capabilities depending on type of vehicle and
temperature. Suitability must be verified by testing under actual conditions.
OPERATING TEMPERATURE:
-40 ˚ F to 120 ˚ F (-40 ˚ C to 48 ˚ C)
CHEMICAL RESISTANCE:
Tested for compatibility with common motor oils, gasoline and diesel fuel.
Limited resistance to brake fluids and other chemicals.
MATERIAL:
UV-stabilized polyurethane elastomer
NO. OF
CHANNELS
2 Channel 10,500 lbs./Tire (4,763 kg)
LOAD CAPACITY PER TIRE
MAX LOAD 70 ˚ F (21 ˚ C)
21,000 lbs./Axle (9,526 kg)
LOAD CAPACITY PER AXLE
MAX LOAD 70 ˚ F (21 ˚ C)
CABLE/HOSE MANAGEMENT COMPONENTS
ASSEMBLY INSTRUCTIONS
CHANNEL CAPACITY - MAX. DIAMETER INCHES (mm)
2 Channels 1.5 in. (38.1 mm) width x 1.5 in. (38.1 mm) height
Cross-Link Base Connector
Illustration at left is
shown with Guard Dog
Cable Protectors. Cross-Link Bridges
also fit select Linebacker Cable Protectors.
CABLE PROTECTOR
P R O T E C T O R B R I D G E
®
CROSS-LINK BRIDGE
NOTE: Channel size 1.5 in. x 1.5 in.
(38.1 mm x 38.1 mm)
Cable Protector Cable Protector Cross-Link
Cross-Link Bridge
CABLE PROTECTOR
#ZIS-CL
Ver: 2/11