Ag Spray Equipment 8650 Series Sprayer - Manual (Page 6)

FIG.5
3. RIGHT BOOM TILT POSITION:
This spring-loaded-to-neutral-center toggle switch controls the
right boom tilt function. Move the switch up and hold to raise
the tip of the right boom and down to lower. Release the
switch, the right boom will stop moving and it will remain in
position. Use this function to raise the tip of the boom to clear
obstructions.
4. LEFT BOOM FOLD/EXTEND:
This spring-loaded-to-neutral-center toggle switch controls the
left boom position. Move the switch up and hold to fold the left
boom and down to extend. Release the switch, the left boom
will stop moving and it will remain at that position.
**IMPORTANT**
Extend the cylinder completely when extending the outer boom
to eliminate outer wing vibration. To insure the wing is locked
down hold the toggle switch down for 5 seconds after the boom
is fully extended.
5. LEFT OUTER BOOM SWING:
This spring-loaded-to-neutral center toddle switch controls the
FIG. 15
left outer boom pivot function. Move the switch up and hold
to pivot the left outer boom in and down to pivot out. Release
the switch, the left outer boom will stop and remain at that
position.
6. RIGHT OUTER BOOM SWING:
This spring-loaded-to-neutral-center toggle switch controls the
right outer boom function. Move the switch up and hold to
pivot the right outer boom in and down to extend. Release the
switch, the right outer boom will stop moving and it will remain
at that position.
7. RIGHT BOOM EXTEND/FOLD:
This spring -loaded-to-neutral-center switch controls the right
boom position. Move the switch up and hold to fold the right
boom and down to extend. Release the switch, the right boom
will stop moving and it will remain in that position.
**IMPORTANT**
Extend the cylinder completely when extending the outer boom
to eliminate outer wing vibration. To insure the wing is locked
down hold the toggle switch down for 5 seconds after the boom
is fully extended.
5 - 8 6 5 0 S E R I E S S P R A Y E R S O P E R A T I O N & M A I N T E N A N C E M A N U A L
SPRAYER OPERATION
Unfolding boom for field use
**CAUTION**
Electrocution hazard. Keep away from power lines. To prevent
serious injury or death from electrocution:
1. Stay well away from power lines when folding or
extending wings. Electrocution can occur without
direct contact.
2. Lower wings completely before moving or transporting.
Note: Tractor should come to a full stop before folding or
unfolding sprayer. Make sure clear of any obstacles overhead or
around sprayer that could come in contact with boom.
1. Before unfolding boom, remove transport using lock
pins (see figure 1) and tower cylinder transport stop
(see figure 2). Reinstall lock pins and tower stop
before transporting sprayer.
2. Raise tilt cylinders by pushing up on “tilt” toggle
switch to raise boom out of transport saddle.