EarthQuake Cinenova 7 - Manual (Page 15)

15
Cinénova 7 Power Amplifiers Cinénova 7 Front Panel Overview
1 2
Cinénova 7 Front Panel
1. Master Power Switch:
Turns the current to the amplifier ON or OFF manually. When
turning on the amplifier via a 12VDC source the switch must be in
the OFF position.
Additionally when adding or removing 12VDC connections or
any other connections the main power circuit breaker needs to
be in the off position. This will help prevent any surges that could
damage your products or cause bodily injury.
2 Peak LED Indicators: .
The Cinénova 7 is equipped with five or seven LED indicators on
the front panel that should remain unlit. These LEDs indicate the
operating status of each corresponding channel. If an LED or all
LEDs remain lit continuously, the amplifier is clipping that
channel and the volume should be turned down immediately to
prevent damage. Its ok for the LED to flicker but it should never
remain on continuously.
LR RR
Seven Channel Power Amplifier
LF CENTER RF
LS RS
Cinénova
Power
7
www.earthquakesound.com