EarthQuake EWS-530C - Manual (Page 3)

Specifications are subject to change without notice 4 www.earthquakesound.com 5
Specifications
Simply tighten the screws by hand using a screwdriver to prevent the
mounting ears from snapping. Some resistance may occur the first few
turns of the screw as it makes its path through the plastic.
LOCATE & MARK THE 2x4’s
Outline the hole using the supplied speaker
template - stay clear from the 2x4’s.
1
CUT THE DRYWALL
Using a drywall saw, cut out the opening.
2
3 CONNECT THE SPEAKER
Attach speaker wire and insert the EWS Edgeless
In-Wall speaker into the wall opening.
SECURE THE SPEAKER
Align the speaker in position and tighten the
screws evenly to secure the unit.
4
PLACE THE GRILLE
Align the grille - speaker cover - in position. Gently
snap grille into place
5
Easy Installation Steps
13 3/4” (349mm) x 9 3/4” (248mm)
12 7/8” (326mm) x 8 7/8” (224mm)
3 3/16”
(85mm)
E W S 5 3 0 C S P E C I F I C A T I O N S
Frequency Response:
Sensitivity:
Nominal Impedance:
Power Handling:
Enclosure Material / Type:
Driver Components:
40Hz - 20kHz
87dB @ 1W/1M
8-Ohm
350 Watts Max
Impact resist ABS plastic
Three-way system using:
two 5.25” low mass stiff kevlar
cone midbass, one 3” low mass
kevlar cone midrange and two 1”
silk dome swiveling NEO tweeter
Grille Finish: White / Paintable
Wire Gauge Recommended:
Weight Per Speaker:
12
6.8 lbs
Mounting Depth: 3 3/16” (85mm)
Outer Dimension:
Cut Out Dimension: 12 7/8” (326mm) x 8 13/16” (224mm)
13 3/4” (349mm) x 9 3/4” (248mm)