Maxsa Innovations Anywhere Light - Manual (Page 2)

1. In order to mount the light securely to a wall or other stable
surfaces, the mounting base needs to be installed. Slide the
the mounting place to separate it from the main body.
2. If you are installing the mounting place on a very hard
surface, you may need to drill holes for the screws first.
The included screw anchors can be used for drywall,
cement, brick, or similar surfaces.
3. Use the two screws supplied to install the mounting plate.
1. Align the base to the mounting plate. Slide the main body
onto the mounting plate until it snaps into place.
At night, the LED lights will remain on for approximately 40
seconds after the last detected movement. If a movement is
detected while the lights are on, the light duration will be reset
and remain on for another 40 seconds.
Depending on your preferences, you can rotate the base on
the mounting plate or make the motion sensor and the light
swivel to aim at different directions.
because
25 feet
fresh
Anywhere
Anywhere
Anywhere
Anywhere
Anywhere
Anywhere
TM
TM
TM
TM
TM
TM