bloom yoga - Manual (Page 13)

2
eng
open). You will hear an audible click. (refer to
illustration 3)
To install nest
– Unfasten all zippers on the nest fabrics, and
position inside frame. The larger body section
should fit onto the side with canopy arch.
(refer to illustration 4)
– Fasten the two zippers on fabric rim around
nest frame. (refer to illustration 5)
– Place mattress into nest and thread the
shoulder, waist and crotch harness straps
through the corresponding slots on the
mattress. (refer to illustration 6 & 7)
To use and adjust safety harness
– To lock the harness, push the tongues on the
ends of the waist straps, connected with the
ends of the shoulder straps, into the buckle on
the crotch strap until locked.
– To unlock the harness, press the central
button. (refer to illustration 8)
– SAFETY NOTE: Every time you place your child
in stroller or whenever you alter the position
of the seat, always check that the harness is
correctly fitted. Tighten the harness until it fits
snugly.
To install canopy
– Attach canopy fabrics to canopy arch by
fastening the two zippers on either side. (refer
to illustration 9)
– Attach canopy fabrics to nest frame by pairing
and fastening the zipper on the bottom of
canopy to the zipper on the outer rim of nest
fabrics.
To use canopy
– The canopy can be used in 3 positions:
retracted, half opened, fully open.
Simultaneously press the two buttons on both
sides of canopy arch to adjust angle.
– When using canopy in half opened mode,
fasten zipper on canopy to tug away loose
fabric. (refer to illustration 10)
Section B: Carry Cot Mode
– Fasten the two zippers located in the middle
and the head section of the nest body. (refer
to illustration 11)
IMPORTANT! Middle and head section
zippers must be properly fastened to ensure
correct angle for baby
– To attach nest shield, wrap elastic edge over
top of nest and fasten the two string loops on
either side of nest shield to the nub on frame.
(refer to illustration 12)
Section C: Bouncer Mode
– Unfasten middle zipper of nest body.
– Fasten zippers on both ends of nest body.
(refer to illustration 13)
– Disengage lock lever, then press the button on
direct opposite side of lock lever. Rotate the
head section of nest body upward. You will
hear an audible click.
– Engage lock lever to lock frame. (refer to
illustration 14)
– You can rock the cradle by applying a push
either on the canopy arch or on the front of