Anthem Audio AVM 50 - Manual (Page 15)

7
1.8 INTERCONNECTS
These illustrations show audio, video, IR, and trigger connectors used between source components, the
AVM 50, displays, and power amplifiers. Note that when RCA cables have coaxial construction and their
impedance is 75 ohms, they are equally suitable for analog video and digital audio.
DVI connection:
Cables with DVI connection on one end and HDMI connection on the other are more reliable than DVI-HDMI
adapters. If you are having a connection problem and an adapter is in use, try eliminating the adapter.
Important notes regarding HDMI cables:
1080p uses twice the bandwidth that 720p and 1080i do – make sure that the cable is suitable for your
application, especially when using a long cable, otherwise the picture may contain pixel dropouts or not
play at all. For runs longer than approximately 20 feet, you may need a repeater or a special connection
system intended to take the place of long HDMI runs – contact your dealer.
BE CAREFUL WHEN INSERTING HDMI CABLES. The connector should slide into the jack easily – do not
insert it on an angle and do not force it in. Each connector contains 19 delicate pins, and cables with
damaged pins can damage the jack. Jacks damaged through misuse are not covered under warranty.
If your HDMI cables have been connected so many times that they are about to wear out, we strongly
recommend that you replace them to prevent damage to any HDMI jacks in your system.
Analog Left
Channel
RCA Black or
White
RCA Red RCA Yellow
Analog Right
Channel
Digital Audio or
Composite Video
RCA Green:
Component Y
RCA Blue:
Component Pb
RCA Red:
Component Pr
Mini DIN HDMI
S-Video
Digital Video
and Audio
1. INTRODUCTION
continued …
Optical
XLR Female
(connects to output)
XLR Male
(connects to input)
Digital Audio Analog Balanced or AES/EBU
1/4” Stereo
Headphone
3.5mm
Mini (Mono)
12V Trigger
IR Emitter