Installation, Installation procedure, Chapter 3 – Vaisala WHP25 User Manual
Page 11
Chapter 3 __________________________________________________ Installation
VAISALA___________________________________________________________9
CHAPTER 3
INSTALLATION
This chapter provides you with information that is intended
to help you install WHP25 Mains Power Supply.
Installation Procedure
Before installation, route the input (AC) power cable near
the mast, which WHP25 Mains Power Supply will be
mounted to. Make sure you selected a pole mast with a
diameter from 99 to 105 mm for installation with the
standard mounting clamp.
To install the WHP25 unit, follow the procedure below.
1.
Remove the four screws holding the cover of the
WHP25 unit. Remove the cover.
2.
Attach the unit to the mast at a suitable place with the
provided accessories and the standard mounting clamp.
Refer to Figure 2 on page 10.