HighPoint RocketRAID 1740 - Manual (Page 12)

RocketRAID 174x Hardware Description/Installation
2 - LED Connections
The RocketRAID 174x has two LED jumpers that are used to indicate the activity and
failure status of hard disks attached to the card’s four SATAII channels. These
jumpers are labeled as CONN# (connector).
The odd numbered pins of each CONN (1, 3, 5, and 7) represent the RR174x’s SATA
channels 1, 2, 3, and 4 respectively. The even numbered pins (top row) are not
utilized.
Note: These connectors were designed for use with SATA/SATAII back-planes and
enclosures (they were not designed for standard 2-pin LED cables). Consult the
system chassis’ manual for more information about LED support, and configuration
options.
CONN1, CONN3
These LED connectors can be used to configure Disk Failure (CONN3) and Disk
Activity (CONN1) indicators for each individual disk attached to the RocketRAID
174x.
BEEP1 - Speaker
Alarm (speaker): The speaker emits and audible alarm in the case of disk/array failure.
JP5
SAF-TE support: this support is dependent upon the system chassis. Not all chassis
models support SAF-TE features. Consult the chassis’s manual for more information.
Port1- Port4
These represent the RocketRAID 174x’s 4 SATAII ports. Depending upon the model,
these ports utilize standard SATA or eSATA (external SATA) connectors.
2-2