ASKO W6441 - Manual (Page 10)

Page 10
Start
Stop
Programs Temperature °F
85
105 175
120 160
205
140
Normal Rinse
Quick
Perma
press
Heavy
Stain Drain
Spin
Hand/
Delicate
Wool
Super quick
THE CONTROL PANEL
W6021 OPERATING INSTRUCTIONS
Door Open Button
Press to open the glass door. (Please note
that the unit must be at the end of a program
to open the glass door.)
Super Rinse
Button
Press to program
seven rinses.
Start/Stop Button
Press to start or stop/
interrupt a program.
Power Button
Press to turn on power to
the machine.
Program Control
Turn to select a program. (Please
note that the dial does not move as
the program advances.)
Power Indicator Light
Glows when the power is
turned on.
Temperature Control
Turn clockwise to select the
wash temperature.
800 RPM Spin Button
Press to reduce spin speed from
1200 rpm to 800 rpm.
No Spin/No Drain
Press to omit the spin and
final drain cycles.
POWER BUTTON
The Power button turns the power to the machine on
and off. When the power is on, the power indicator light
glows red. The power must be on before you can open
the door, set the programs or start the machine.
START/STOP BUTTON
Once you’ve selected the program and options, press
this button to start the washer.
To stop the washer during a program, press and hold
this button down until the unit stops (about 3 seconds).
DOOR OPEN BUTTON
When the washer has completed a program, press this
button to open the door. Note that the power must be on
and the unit must be at the end of a program and the
water drained before the door will open.
NOTE: For instructions on how to open the door
manually in case of power failure, see page 24.
PROGRAM CONTROL KNOB
Turn this knob to the desired program. The table on the
following page defines each program.
TEMPERATURE CONTROL KNOB
Turn this knob clockwise to the desired wash
temperature. Always refer to the garments’ care labels
for recommended wash temeratures.
Please note that the wash temperature for the Wool
Wash and Hand Wash/Delicate programs will not heat
higher than 105° F.
WARNING!
To reduce the risk of electric shock or injury to persons, read the ”Important Safety
Instructions” section on page 2 before operating this appliance.
OPTION BUTTONS
Super Rinse
Press this button to add two rinses. Press the button
again to turn this option off. (This option cannot be
cancelled after the main wash water has pumped out.)
This option is recommended for persons with sensitive
skin or allergies.
No Spin/No Drain
Press this button to omit the spin cycles in all programs
along with the final drain. If you select this option, the
unit will stop with water in the drum, so you will have to
run the Drain program before you can open the door.
800 RPM
Press this button to reduce the spin speed from 1200
rpm to 800 rpm. This option is for delicate fabrics that
should not be spun at high speeds. Note: This option
does not apply to the Rinse and Spin programs.)
CANCELLING A PROGRAM
To cancel a program after it has started, press and hold
the Start/Stop button until the unit stops. If there is water
in the unit, you will have to turn the Program Control
knob to Drain then press Start. The water will drain and
the unit will stop in 30 to 45 seconds. You can then open
the door.