Ronbow 200223 - Manual

Installation Sheet
www.ronbow.com
Step 1 :
Step 2 :
Ronbow Corporation, All Rights Reserved.
Ceramic Vessel
Model: 200223
Step 3 :
Step 4 :
Position countertop opening to ensure
clearance between the lavatory, faucet
and backsplash.
Position and drill a 6-11/16” hole in the
countertop
See Figure 1.
If using RONBOW drain, place a
generous portion of plumbers’ putty
(Not Provided) under drain cap and
insert whole drain body inside the
bowl and through the countertop
(There may be a small beveled rubber
washer packaged with your drain, please
discard this and use plumbers’ putty instead)
See Figure 3.
Apply a continuous bead of silicon
sealant (Not Provided) around the
edge of the countertop cutout.
Position the lavatory on the
countertop. Press down firmly on the
lavatory. Apply a thin bead of silicone
sealant (Not Provided) where the
lavatory meets the countertop
See Figure 2.
From under the drain, insert the thick
rubber washer and screw on and
tighten the metal nut. Remove exess
plumbers’ putty
See Figure 3.
Above Counter Sinks
Note : Figure 1.
Figure 2.
Figure 3.
For Ceramic Sinks with overflow &
Faucet Deck
Step 5 : Connect the trap to the drain. Run
water into the lavatory. Check all
connections for leaks
countertop
Apply sealant
Cutout
Drain
Drain Nut
Tailpiece
Thick rubber
washer
P-trap
Plumbers Putty