Red Lion ILS - Manual

1
DESCRIPTION
These devices, when installed across an inductive load, such as a contactor,
solenoid or relay, will suppress transient surges during a switching. This will
enhance relay life and provide increased reliability of operation.
There are two devices available, one for use in 115 volt circuits and one for
use in 230 volt circuits.
INDUCTIVE LOAD SUPPRESSOR
Fully slide PVC insulating tubing over Model ILS leads, as shown.
Caution: Ensure VAC is “OFF” before installing Model ILS.
ILS
ORDERING INFORMATION
ILS SPECIFICATIONS *
*
NOTE: These devices will suppress most transient surges. However, if the device heats up or stops functioning after a short period of time a higher joules rated device may be required.
Bulletin No. ILS1/2-D
Drawing No. LP0151
Released 06/13
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL NO. DESCRIPTION PART NUMBER
ILS1 115 VAC Inductive Load Suppressor ILS11500
ILS2 230 VAC Inductive Load Suppressor ILS23000
RATED VOLTAGE DEVICE MODEL
NUMBER
AC VOLTS DC VOLTS
SINGLE PULSE
TRANSIENT
ENERGY JOULES
POWER DISSIPATION
WATTS
CLAMPING VOLTAGE
VOLTS
RATED PEAK
SINGLE PULSE
TRANSIENT CURRENT (AMPS)
ILS1 130 175 6500 80 1.0 340 V @ 100 A
ILS2 275 370 6500 150 1.0 710 V @ 100 A
Do not dispose of unit in trash - Recycle