Red Lion PMK7A - Manual

1
DIMENSIONS In inches (mm)
This panel mount adapter kit is used to mount 1/8 DIN instruments, vertically or horizontally into an existing 1/4 DIN panel cut-out. The kit includes two durable
steel mounting plates painted black and a neoprene gasket. The Adapter Kit, when used with a unit which has NEMA 4/IP65 specifications, will meet NEMA 4/IP65
requirements when properly installed. Red Lion Controls 1/8 DIN products include Temperature and Process Control Units (Models TCU, TSC, PCU, and PSC), and
PAX Series.
MODELS PMK5, PMK7, and PMK7A - PANEL MOUNT ADAPTER KITS
ORDERING INFORMATION
Bulletin No. PMK5-D
Drawing No. LP0280
Revised 3/08
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL NO. DESCRIPTION PART NUMBER
PMK5 Panel Mount Adapter Kit (1/4 DIN TO 1/8 DIN) PMK50000
PMK7A
PMK7
Panel Mount Adapter Kit (1/4 DIN TO CUB)
Panel Mount Adapter Kit (1/4 DIN TO 1/16 DIN)
PMK7A000
PMK70000
MOUNTING PLATE ADAPTER PLATE
PMK5 - 1/4 DIN TO 1/8 DIN ADAPTER
INSTALLATION
TYPICAL VERTICAL MOUNT INSTALLATION
1. Remove the paper backing from the
adhesive side of the adapter gasket
(included with adapter kit) and
carefully apply the gasket to the front
of the existing panel cut-out.
2. Apply the panel gasket (provided with
the unit) to one side of the mounting
plate. Slide the mounting plate over
the unit with the gasket facing the
Bezel of the unit.
3. Insert the unit with mounting plate
into the panel cut-out from the front.
Slide the adapter plate over the rear of
the unit. The protrusion on the adapter
plate is designed to fit into the
existing 1/4 DIN panel cut-out to
properly position the unit.
4. Refer to the installation section of the
manual, supplied with the instrument,
to complete the installation.