Red Lion PMK6A - Manual (Page 2)

The panel mount adapter kit is used to mount CUB5 units into existing 1/8
DIN panel cut-outs. The kit includes two black painted durable steel mounting
plates and a sponge rubber gasket. The Adapter Kit, when used with a unit
which has NEMA 4/IP65 specifications, will meet NEMA 4/IP65 requirements
when properly installed. Red Lion Controls CUB5 products include Counters,
Timers, Temperature, Process and Rate units.
PANEL MOUNT ADAPTER KIT - 1/8 DIN TO CUB5
DIMENSIONS In inches (mm)
INSTALLATION
TYPICAL HORIZONTAL MOUNT INSTALLATION
1. Remove the paper backing from the adhesive side of the
adapter gasket (included with adapter kit) and carefully
apply the gasket to the front of the existing panel cut-
out.
2. Carefully remove the center section of the panel
gasket (provided with the unit) and discard.
Slide the panel gasket over the rear of the
unit to the back of the bezel.
3. Slide the mounting plate over the
rear of the unit to the back of the
unit bezel.
4. Insert the unit with mounting plate
into the panel cut-out from the
front. Slide the adapter plate over
the rear of the unit. The
protrusion on the adapter plate is
designed to fit into the existing
1/8 DIN panel cut-out to properly
position the unit.
5. Refer to the installation section of
the manual, supplied with the unit,
to complete the installation.
ORDERING INFORMATION
MOUNTING PLATE ADAPTER PLATE
MODEL NO. DESCRIPTION PART NUMBER
PMK6A Panel Mount Adapter Kit (1/8 DIN to CUB5) PMK6A000
Red Lion Controls
20 Willow Springs Circle
York PA 17406
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
Red Lion Controls AP
Unit 101, XinAn Plaza
Building 13, No.99 Tianzhou Road
ShangHai, P.R. China 200223
Tel +86 21 6113-3688
Fax +86 21 6113-3683
Red Lion Controls BV
Printerweg 10
NL - 3821 AD Amersfoort
Tel +31 (0) 334 723 225
Fax +31 (0) 334 893 793