ATEN VS-291 - Manual (Page 7)

- 5 -
Installation
Installation is simply a matter of plugging in cables. Refer to the
diagrams above as you follow the step by step directions below:
1. Plug the monitor cable into the unit's Monitor port.
2. Plug the female end of a male to female video extender cable
into any available video port on the unit's rear panel; plug the
male end of the cable into the computer's video output port.
Note: The video extender cable does not come with the
package, and must be purchased separately (part no.
2L-2401).
Plug the power adapter (supplied with this package) into an AC
source; plug the adapter's power cable into the unit's Power Jack.
Power On all equipment.
vs2491.fm Page 5 Thursday, March 30, 2006 11:35 AM