CDN DTC1-G - Air Thermometer & Clock EN User Manual

Air thermometer & clock, Perfect for, Easy to use

Advertising
background image

Perfect For

Refrigerator/Freezer

Indoor/Outdoor

Easy To Use

2-way mounting: stand/Velcro

®

Adhesive sensor for easy mounting

Features

117"/3 m sensor cable

2 channels

Big digit

Clock

ABS plastic

Sliding mode switch

Battery and instructions included

Note:

Remove sticker from display before use.

Note:

In the following instructions, names of the control

buttons are shown in CAPS. Function information that appears

on the display is shown in

BOLD CAPS.

Battery Installation

Battery is installed. Remove plastic tab to allow

power. Replace battery when LCD becomes dim.

1. Remove battery cover on the back by sliding it

in the direction of the arrow.

2. Install one LR44 battery, positive (+) side up.

A brief alarm sounds.

3. Replace the battery cover until it clicks shut.

Operating Instructions

A. Temperature Scale

Slide switch to °F or °C on the back of the case

to select temperature reading in Fahrenheit

or Celsius.

B. Temperature

1. IN displays current temperature at the panel

of the DTC1-G.

2. OUT displays sensor temperature.

Note:

The sensor is sealed inside the weatherproof

housing. This sensor (OUT) responds less quickly to

temperature changes than the sensor in the case (IN).

C. Set Clock

1. Slide switch to CLOCK on the back of the case.
2. Press the HR and/or MIN buttons on the back

of the case to enter the correct time. Press and

hold for fast advance.

3. Slide switch back to TEMP °F or TEMP °C

on the back of the case.

4. Press the bar (on the front under the display)

to display the time.

D. Mounting

1.

Velcro

®

a. Remove the paper backing from one side

of the Velcro

®

tab and adhere to back of case

above battery cover.

b. Determine where the case will be mounted.

Wipe the surface area clean, remove the

paper backing from opposite side of the

Velcro

®

tab, and adhere to surface by

pressing firmly. Wait 15 minutes for adhesive

to set before removing case.

Model: DTC1-G

Air Thermometer & Clock

-58 to +158°F/-50 to +70°C

����� ���

������

�������

���� ������

�������

���� ������

�������� �����

�������� ����

�������

Advertising