CDN INTP626X - ProAccurate® Infrared/Thermocouple Probe Thermometer EN - Manual

Perfect For
• Non-contact surface temperatures
• Internal temperature measurement with
thermocouple probe
Easy To Use
• Rapid response
• Data-hold
• One-button operation
• HACCP check lights & icons
Features
• Water resistant
• Shatterproof
• Dual function
• Maximum, minimum and lock
for continuous scanning
• White light target illumination
• Distance:spot = 2.5:1
• Battery status indication
• Food-safe ABS plastic with BioCote ®
• Auto-off after 15 seconds
• Pouch
• Battery and instructions included
Get Professional Results
Every Time!
Monitoring temperature is essential to keeping food
safe. The versatile INTP626X is perfect for any
application. Simply point the infrared sensor lens
toward the target and press SCAN to get a quick
reading of surface temperatures or flip down the
rapid-response thermocouple probe to measure
internal temperatures. Integrated HACCP check
lights and icons instantly show if temperatures are
within HACCP guidelines for safe food temperatures.
Minimum, Maximum and Lock
The INTP626 also offers Minimum, Maximum, and
Lock modes. Minimum mode displays the lowest
temperature among multiple targets. Maximum mode
displays the highest temperature among multiple
targets. While Lock mode continuously displays the
temperature for up to 60 minutes. This is particularly
useful for continuous temperature monitoring.
Note: Remove sticker from display before use.
Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that appears
on the display is shown in BOLD CAPS.
Battery Installation
Power off the unit before installing the battery.
A malfunction may occur if the power is on when
the battery is installed. If a malfunction
occurs, restart the device.
1. Holding the device on the outside
edges (do not press buttons), pick
off the rubber cap on the battery
cover using a small Phillips
screwdriver.
2. Remove the screw on the battery
cover by turning it counter
clockwise.
3. Remove the battery cover,
top edge first.
4. Install two 1.5V AAA batteries
observing polarity shown in
compartment.
Model: INTP626X
ProAccurate ® Infrared/
Thermocouple Probe Thermometer
Infrared: -67 to +482°F/-55 to +250°C
Thermocouple: -67 to +626°F/-55 to +330°C
probe
HACCP check lights
DUAL
battery cover
rubber cap
(screw location)
white light
infrared lens
infrared reading
probe reading
SCAN button
PROBE button
3
4
1
2