Hawkeye Goshawk User Manual
Goshawk level transmitter
1/2 TURN
TO STOP
Installation of Electronic
Cover Plate
► 9/16 Open-end wrench
(for Redtail)
► 1/2 Open-end wrench
(for Roadside)
Installation onto Gauge Head
► 7 / 16 Open End Wrench
Calibration (Zero & Span)
► Connections to you PLC or a
Fluke 780 (or Eq.) 24 VDC
Loop Calibrator
► 1/8” Blade screwdriver
This document contains the recommended basic procedures installing and calibrating the Hawkeye Industries Goshawk Level Transmitter
for use on a Redtail or Roadside Gauge Head. For more comprehensive instructions, please refer to the Goshawk Operation and Trou-
bleshooing Guide.
Requirements
The gauge board, indicator, float, and gauge head, shall be in
place per their respective installation instructions prior to Goshawk
installation.
Tools
Parts Required
Goshawk Installation on Gauge Head
TANK PREPARATION | GAUGE BOARD KIT INSTALLATION | FLOAT GUIDE KIT INSTALLATION | GAUGE HEAD INSTALLATION |
GOSHAWK INSTALLATION
Quick Start Installation Instructions
Goshawk Level Transmitter
QTY
Part
►
1
Goshawk Level Transmitter
►
2
1/4-20 UNC x 3/4 Hex Cap screw (included)
Installation on Redtail
►
1
Redtail Gauge Head with
►
1
Redtail Electronic Cover Plate installed
Installation on Roadside
►
1
Roadside Gauge Head with:
►
1
Roadside Electronic Cover Plate installed
1
2
3
4
If the electronic cover plate is not already installed, remove the standard
cover plate from the Indicator (Open) side of the gauge head, and replace
with the appropriate Electronic Cover Plate for your gauge head.
Turn the indicator cable spool IN THE EMPTYING DIRECTION (CLOCK-
WISE) until the the indicator is in the empty position (top of gauge board).
Immobilize the spool. (cover omitted for clarity)
Goshawk Quick Installation Instructions, March 2014. Replaces May 2012 document
1
Turn the Transition Coupler on the Goshawk Transmitter IN THE EMPTY-
ING DIRECTION (COUNTER-CLOCKWISE) until it stops. DO NOT OVER
TURN, AS DAMAGE WILL OCCUR. Then turn the Transition Coupler on
the Goshawk Transmitter IN THE FILLING DIRECTION (CLOCKWISE)
one-half turn
Aligning the tangs on the transmitter with the cover plate bolt holes and
fasten with the 1/4 NC Hex Cap Screws. Ensure the transition coupler
mates with the gauge head axle without binding by turning the reel a few
times before tightly securing the transmitter to the cover plate.
REDT
AIL
ROADSIDE
REDT
AIL
ROADSIDE